Off Road Parts

BS SLA Factory Activated batteries have all the features of Maintenance Free batteries with the increased power of a radial grid design and additional plates.

These batteries are prefectly suitable for motorcycles, scooters, ATV's, UTV's, watercraft, and lawnmowers.

Features:

• Wet charged factory activated and ready to go
• Higher life cycle (up to three times longer than conventional batteries)
• Easy to install (no risk of spilling acid)
• Plate sulfation minimized
• AGM construction (absorbed acid)
• VRLA battery (Valve Regulated Lead Acid)
• Sealed, no gas emission through venting hole (under normal operation)
• Increased power and extended life
• Extreme vibration resistance

Find the correct fitment for your motorcycle here: BS Battery Fitment Guide

BSLi battery is a part of our LiFePO4 range. Designed for the most demanding riders, the battery offers maximum starting performance, further safety and higher cycle life.
With its ultra-lightweight design, the battery provides faster acceleration to all powersport vehicles.

Useful, this battery is equipped with a voltage indicator to check the state of charge at any time.

FEATURES

• Ready to use
• Lighter weight – up to 70% than lead acid batteries
• Multi-positioning mounting – up to 180°
• Extensive cycle life – over 2000 cycles
• Fast charging
• Very safe and environmental friendly
• Very low self discharge
• Can start engines after a long period of storage
• Robust brass terminals
• Heat temperature resistance up to 230 °C
• Waterproof design
• Spacers to adjust the dimensions if necessary, to make sure new battery can be installed firmly in the battery box

UPGRADE FROM:

Find the correct fitment for your motorcycle here: BS Battery Fitment Guide

The BT02 is a battery & alternator tester designed to save time on electrical issues, it gives a instant diagnosis.

With all the features inside an automatic, you cannot use it wrong.

FEATURES

• For 12V battery
• Test the condition of your battery and alternator
• Connect the crocodile clip to battery terminal and check alternator or battery
• Easy to use

INSTRUCTIONS

1. Connect the red crocodile clip to the positive (+) battery terminal
2. Connect the black crocodile clip to the negative (-) battery terminal

Battery Check

• Switch on the vehicle lights for 1-2 minutes
• Disconnect the battery from the vehicle
• Wait 10 minutes
• Connect the tester

Alternator Check

• Run the vehicle with all electrical equipment off (lights, radio...)
• Run the vehicle with all electrical equipment on (lights, radio...)
• The green LED should light on both tests meaning the alternator is GOOD
• A red LED indicates the alternator is over charging : must be controlled
• No LED light indicates the alternator may not be charging : must be controlled

BTX14 battery is a part of our SLA range. Designed to make the user life easier, this 12V 12.6Ah battery is ready to use, 100% maintenance free and completely spill proof.

Extremely simple to install & carry, this BTX14 battery offers increased power, extended life and maximum reliability to all powersport vehicles that require high performance.

Cross Reference:

• Yuasa / Top Lite / Katana: YTX14-BS
• Motobatt: MBTX12U / MBYZ16H
• Powerroad: YG14-BS
• USPS: USX14-BS

Specifications:

• Technology: SLA
• Voltage (V): 12
• Capacity 10hr (Ah): 12
• Capacity 20hr (Ah): 12.6
• CCA (A): 200
• Polartiy:
• Terminal:
• Dimensions (mm): 150 x 87 x 145

Features:

• Wet charged factory activated and ready to go
• Higher life cycle (up to three times longer than conventional batteries)
• Easy to install (no risk of spilling acid)
• Plate sulfation minimized
• AGM construction (absorbed acid)
• VRLA battery (Valve Regulated Lead Acid)
• Sealed, no gas emission through venting hole (under normal operation)
• Increased power and extended life
• Extreme vibration resistance

Find the correct fitment for your motorcycle here: BS Battery Fitment Guide

U1-9 battery is a part of our SLA range. Designed to make the user life easier, this 12V 28Ah battery is ready to use, 100% maintenance free and completely spill proof.

Extremely simple to install & carry, this U1-9 battery offers increased power, extended life and maximum reliability to all powersport & garden vehicles that require high performance.

Specifications:

• Technology: SLA
• Voltage (V): 12
• Capacity 20hr (Ah): 28
• CCA (A): 300
• Polartiy:
• Terminal:
• Dimensions (mm): 195 x 125 x 176

Features:

• Wet charged factory activated and ready to go
• Higher life cycle (up to three times longer than conventional batteries)
• Easy to install (no risk of spilling acid)
• Plate sulfation minimized
• AGM construction (absorbed acid)
• VRLA battery (Valve Regulated Lead Acid)
• Sealed, no gas emission through venting hole (under normal operation)
• Increased power and extended life
• Extreme vibration resistance

Find the correct fitment for your motorcycle here: BS Battery Fitment Guide

U1R-9 battery is a part of our SLA range. Designed to make the user life easier, this 12V 28Ah battery is ready to use, 100% maintenance free and completely spill proof.

Extremely simple to install & carry, this U1R-9 battery offers increased power, extended life and maximum reliability to all powersport & garden vehicles that require high performance.

Specifications:

• Technology: SLA
• Voltage (V): 12
• Capacity 20hr (Ah): 28
• CCA (A): 300
• Polartiy:
• Terminal:
• Dimensions (mm): 195 x 125 x 176

Features:

• Wet charged factory activated and ready to go
• Higher life cycle (up to three times longer than conventional batteries)
• Easy to install (no risk of spilling acid)
• Plate sulfation minimized
• AGM construction (absorbed acid)
• VRLA battery (Valve Regulated Lead Acid)
• Sealed, no gas emission through venting hole (under normal operation)
• Increased power and extended life
• Extreme vibration resistance

Find the correct fitment for your motorcycle here: BS Battery Fitment Guide

BSLi-04/06 battery is a part of our LiFePO4 range. Designed for the most demanding riders, this 12.8V 4Ah (48Wh) battery offers maximum starting performance, further safety and higher cycle life. With its ultra-lightweight design, this BSLi-04/06 battery provides faster acceleration to all powersport vehicles.

Useful, this battery is equipped with a voltage indicator to check the state of charge at any time.

Replacement Conversion from BS Batteriers SLA:

BTZ10S, BTZ12S, BTZ14S, BTX12, BTX14, BTX14AH / BB14-A2/B2, BT12B-4, BT14B-4, BT12A, BB12A-A2, BB14A-A2

Specifications:

• Technology: LiFePO4
• Voltage (V): 12.8
• Capacity 10hr (Ah): 4
• Power (Wh): 48
• CCA (A): 280
• Polartiy:
• Terminal:
• Dimensions (mm): 134 x 65 x 92

FEATURES

• Ready to use
• Lighter weight – up to 70% than lead acid batteries
• Multi-positioning mounting – up to 180°
• Extensive cycle life – over 2000 cycles
• Fast charging
• Very safe and environmental friendly
• Very low self discharge
• Can start engines after a long period of storage
• Robust brass terminals
• Heat temperature resistance up to 230 °C
• Waterproof design
• Spacers to adjust the dimensions if necessary, to make sure new battery can be installed firmly in the battery box

UPGRADE FROM:

Find the correct fitment for your motorcycle here: BS Battery Fitment Guide

BSLi-10 battery is a part of our LiFePO4 range. Designed for the most demanding riders, this 12.8V 6Ah (90Wh) battery offers maximum starting performance, further safety and higher cycle life. With its ultra-lightweight design, this BSLi-10 battery provides faster acceleration to all powersport vehicles.

Useful, this battery is equipped with a voltage indicator to check the state of charge at any time.

Replacement Conversion from BS Batteriers SLA:

BTX20L, BTX20HL, BTX24HL, SLA12-19, BTX20L-BS, BTX20HL-BS, BTX24HL-BS, SLA12-19-BS, B50-N18L-A/A2/A3, 51913, 51814

Specifications:

• Technology: LiFePO4
• Voltage (V): 12.8
• Capacity 10hr (Ah): 6
• Power (Wh): 72
• CCA (A): 360
• Polartiy:
• Terminal:
• Dimensions (mm): 148 x 86 x 105

FEATURES

• Ready to use
• Lighter weight – up to 70% than lead acid batteries
• Multi-positioning mounting – up to 180°
• Extensive cycle life – over 2000 cycles
• Fast charging
• Very safe and environmental friendly
• Very low self discharge
• Can start engines after a long period of storage
• Robust brass terminals
• Heat temperature resistance up to 230 °C
• Waterproof design
• Spacers to adjust the dimensions if necessary, to make sure new battery can be installed firmly in the battery box

UPGRADE FROM:

Find the correct fitment for your motorcycle here: BS Battery Fitment Guide

BSLi-02 battery is a part of our LiFePO4 range. Designed for the most demanding riders, this 12.8V 2Ah (24Wh) battery offers maximum starting performance, further safety and higher cycle life. With its ultra-lightweight design, this BSLi-02 battery provides faster acceleration to all powersport vehicles.

Useful, this battery is equipped with a voltage indicator to check the state of charge at any time.

Replacement Conversion from BS Batteriers SLA:

12N5.5-3B, BB4L-B, BB5L-B, BB7C-A, BB7L-B2, BTX4L+ / BTZ5S, BTX5L / BTZ6S, BTX7L, BTZ7V, BTZ8V

Specifications:

• Technology: LiFePO4
• Voltage (V): 12.8
• Capacity 10hr (Ah): 2
• Power (Wh): 24
• CCA (A): 140
• Polartiy:
• Terminal:
• Dimensions (mm): 107 x 56 x 85

FEATURES

• Ready to use
• Lighter weight – up to 70% than lead acid batteries
• Multi-positioning mounting – up to 180°
• Extensive cycle life – over 2000 cycles
• Fast charging
• Very safe and environmental friendly
• Very low self discharge
• Can start engines after a long period of storage
• Robust brass terminals
• Heat temperature resistance up to 230 °C
• Waterproof design

UPGRADE FROM:

Find the correct fitment for your motorcycle here: BS Battery Fitment Guide

BSLi-01 battery is a part of our LiFePO4 range. Designed for the most demanding riders, this 12.8V 2Ah (24Wh) battery offers maximum starting performance, further safety and higher cycle life. With its ultra-lightweight design, this BSLi-01 battery provides faster acceleration to all powersport vehicles.

Useful, this battery is equipped with a voltage indicator to check the state of charge at any time.

Replacement Conversion from BS Batteriers SLA:

BB3L-A/B

Specifications:

• Technology: LiFePO4
• Voltage (V): 12.8
• Capacity 10hr (Ah): 2
• Power (Wh): 24
• CCA (A): 140
• Polartiy:
• Terminal:
• Dimensions (mm): 92 x 52 x 90

FEATURES

• Ready to use
• Lighter weight – up to 70% than lead acid batteries
• Multi-positioning mounting – up to 180°
• Extensive cycle life – over 2000 cycles
• Fast charging
• Very safe and environmental friendly
• Very low self discharge
• Can start engines after a long period of storage
• Robust brass terminals
• Heat temperature resistance up to 230 °C
• Waterproof design

UPGRADE FROM:

Find the correct fitment for your motorcycle here: BS Battery Fitment Guide